Fracarro SIG7710 Instructions D'emploi page 36

5.2.9 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the
headend programming
menus
HEADEND
SETUP
(not available)
Automatic
acknowledgement of
the headend c onnected
to the TPE
Export the headend
configuration to another one
Restore the module
defaults s etting
Restart the module
Emulation of the KTP
programmer
KTP
EMULATION
Confirm the settings by pressing the
NAVIGATION
NAVIGATION OSD
HEADEND SCAN
COPY
FACTORY SETUP
SET ADDRESS
RESET MODULE
KTP
EMULATION
pressing the S key after the modules programmation.
36
Refer to the SIG7710 general
SIG7710 programming menu
Automatic search of the
headend or the c onnected
device. After searching, the
Module s earch....
main menu can be seen
from the NAVIGATION
function
All
SIG7710
modules
Address not Address not valid valid
All
SIG7710
modules
The function is not
available for the
V=OUTPUT
programming of the
SIG7710 module
key; save the settings by
Yes=V NO=X
Read-only
Yes=V NO=X