Publicité
Les langues disponibles
Les langues disponibles
7.
Hold the tool firmly.
8.
Make sure the blade is not contacting the work-
piece before the switch is turned on.
9.
Keep hands away from moving parts.
10. Do not leave the tool running. Operate the tool
only when hand-held.
11. Always switch off and wait for the blade to come
to a complete stop before removing the blade
from the workpiece.
12. Do not touch the blade or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
13. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
data.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
....................alternating current
.......................no load speed
.......................Class II Construction
.../min....................revolutions or reciprocation per
minute
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Selecting the cutting action
This tool can be operated with an orbital or a straight line
(up and down) cutting action. The orbital cutting action
thrusts the blade forward on the cutting stroke and
greatly increases cutting speed.
To change the cutting action, just turn the cutting action
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting action.
Position
0
USD201-2
Switch action
CAUTION:
•
Before plugging in the tool, always be sure that the
tool is switched off.
To start the tool, slide the switch lever to the "I" position.
To stop the tool, slide the switch lever to the "O" position.
4
001931
1
Cutting action
For cutting mild steel,
Straight line
stainless steel and plastics.
cutting action
For clean cuts in wood
and plywood.
Small orbit
For cutting mild steel,
cutting action
aluminum and hard wood.
For cutting wood and
Medium orbit
plywood.
cutting action
For fast cutting in
aluminum and mild steel.
For fast cutting in
Large orbit
wood and plywood.
cutting action
001932
1
1. Cutting action
changing lever
006376
Applications
1. Switch lever
Publicité
