Genesis GLMT12 Manuel D'utilisation page 10

aSSEMBLY anD aDJUSTMEnTS
Warning:
follow all important safety warning and instructions before using this tool.
Warning:
or removal of the battery pack
Installing or Removing the Battery Pack (FIG 2)
• To install the battery pack, insert the battery pack (1) into
the tool housing (2) as shown in FIG 2. Always insert it
all the way until it locks in place with a little click. Lightly
pull on the battery to ensure it is locked into place and
will not accidentally fall out of the tool, causing an injury.
• Do not use force when inserting the battery pack. If the
battery does not slide in easily, it is not being inserted
correctly.
• To remove the battery pack, withdraw it from the tool
while depressing the tabs (3) on both sides of the battery
pack.
Installing and Removing Accessories (FIG 3)
Warning:
switch in the locked or off position before any assembly, adjustments or
changing accessories
To install the saw blade or scraper blade
1. Loosen and remove the cap screw (1) and the washer (2) from the shaft flange (4) using Allen
wrench (3) provided.
2. Place the accessory over the shaft flange (4). The shaft flange of this tool comes with a 4-pin
design. Make sure the holes on the accessory properly engage those 4 pins and the accessory
is flush against the shaft flange.
3. Put the cap screw (1) and the washer (2) back on. Make sure the concave side of the washer (2)
is facing the accessory. Tighten the cap screw securely using Allen wrench (3) provided.
See FIG 3
12V Multi-Purpose Oscillating Tool
Operator's Manual
To reduce the risk of serious personal injuries, read and
always be sure that the tool is switched off before insertion
.
always disconnect battery pack from tool or place the
.
6
3
5
1
2
2
Fig 2
4
GLMT12
3
1
Fig 3