velombra Magical Manuel Utilisateur page 25

PRODUCT FEATURES
STAINLESS STEEL The stainless steel components (AISI 304) require no maintenance aside from regular cleaning
and protection with the kit provided. The appearance of micro-oxidation, most frequently in
maritime environments characterized by salt spray, does not affect the quality and durability
of the product such oxidations are believed to be normal. Should you wish to remove the rust
spots, use a scouring pad or metal bristle brush, both of which must be used solely following the
grain of the satin finish (stainless steel). The protective film of chromium oxide (autopassivation)
will reset in a natural way with the only exposure to air, without any intervention by the user.
ALUMINIUM The presence of marks and scratches is considered a fault only if these are visible at a distance of
2 meters.
Do not use acid to clean the painted aluminum, but only mild soap and water.
FINISH
Rev. 2 - 06.2012 VELOMBRA SRL  USER MANUAL  MAGICAL
PRODUCTS FEATURES
NON COMPLIANCE/ DEFAULT
If the signs and/or dents are visible at a distance of 2 meters these are to be
considered a defect.
Orange peel: the surface of the coating film has an uneven look like orange peel.
Blistering: bumps on the surface of the coating film in various sizes and frequency.
Sagging of the outer layer: localized and well defined irregular accumulations of
coating products, in the form of rounded edges and shallow that affect the outer
layer.
"Posting - Veneer: the coating film lifts from the substrate in
form of small flakes."
Porosity - Cissing: Small holes like craters or indentations in the surface of the
coating film, ranging in size: from small pinhole up to a diameter of up to 1 cm.
Impurities in the outer and inner layers: the coating film has a rough and irregular
surface, easily perceptible to the touch.
"Scrapings for interference: the coating film is damaged and
presents lesions of varying depth and extent depending on the cause."
23 of 70