velombra Magical Manuel Utilisateur page 24

PRODUCTS FEATURES
PRODUCT FEATURES
VELOMBRA FABRICS The fabrics are "dyed in the piece", this can cause a non-perfect uniformity and consistency of color.
WOOD WARNING: It is good to remember that any kind of wood type placed outside, and directly exposed to weather elements, may look
"lived" even after a relatively short period of time. This manifests itself mainly with:
surface.
Since wood is a natural material, there are differences in color and grain and therefore all elements are different. Furthermore,
depending on the viewing angle the aspect is quite different because of the iridescent nature of the material. The samples and
photographic reproductions are thus regarded as indicative and not binding.
The wood is placed under a protective treatment performed in autoclaving which allows a better resistance to attack by fungus
and mold. This treatment is green (due to the salts used for impregnation), and is performed before painting the beams. The
appearance of green stripes on the wood as a result of leaching of the paint finish by bad weather is normal in case of bright
colors. In this case you must proceed with the maintenance as indicated in the manual.
The beams may present vertical stripes of different shades. This is normal and is due to stacking that occurs inside the autoclave
during the impregnation treatment (the beams are spaced apart by transverse beams).
The presence of resin is a characteristic of coniferous wood.
A dimensional variation of wood products after exposure to moisture is normal. The reference humidity for the measuring is 12%
(defined in the UNI EN390: 1997).
FLOOR The floor may dent in collisions or falling objects and the implementation of concentrated loads on a small area, such as chairs
with wheels, high heels and ladders is not suitable.
The floor can scratch as a result of contact with small objects such as nails or stones present beneath the soles of shoes.
At the time of delivery, the floor may be different from that of the samples after exposure to light which causes a change in the
wood color.
MOTORS Electrical system: it must be performed by a licensed electrician who shall issue a certificate of conformity of the electrical system.
The system has to have an appropriate degree of protection being installed outside. A licensed electrician is able to properly size
the system and choose the right components (adequate IP protection).
Any voltage drop or radio interference may result in loss of the limit switches of the engines. In this case it is necessary to proceed
with a new programming as indicated in the Manual.
22 of 70 VELOMBRA SRL  USER MANUAL  MAGICAL
NON COMPLIANCE/ DEFAULT
The detachment of a slat from the beams is considered a
defect.
Rev. 2 - 06.2012