Turning Power On/Off - Sharp PN-E803 Manuel D'installation

Caution
• Turn on the monitor first before turning on the PC or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
Turning on the main power
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button or POWER switch to turn the power
ON/OFF.
Status
Green lit Power on
Orange lit Power off (Standby mode)
Green flashing Input signal waiting mode
Turning Power On/Off
nMode setting
When the monitor is turned on for the first time after being
shipped from the factory, the mode setting screen will be
displayed.
(1)Press
(2)Press
YES:
• STANDBY MODE is set to LOW POWER.
• Compared to when set to STANDARD, the current
• While the monitor is in standby mode, control via LAN will
• While the monitor is in standby mode/input signal waiting
• Depending on the input signal, the monitor may not switch
NO:
• STANDBY MODE is set to STANDARD.
• Compared to when set to LOW POWER, the startup/
nDate/time setting
• If the time has yet to be set when the monitor is first turned
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
Power switch Power LED
Status of the monitor
•
•
•
•
•
•
or to select YES or NO.
ENTER
.
consumption is reduced while the monitor is in standby
mode/input signal waiting mode, but the startup/return time
from standby mode/input signal waiting mode becomes
longer.
be disabled.
mode, only certain RS-232C commands can be used.
to input signal waiting mode and may not return from input
signal waiting mode.
return time from standby mode/input signal waiting mode
is reduced, but more power will be consumed in standby
mode/input signal waiting mode.
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/ /
01 / 01 / 20 15
OK···[ENTER] CANCEL···[RETURN]
1. Press or to select the date and time, and
press or to change the numerical values.
2. Press .
ENTER
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
Set the date in "Month/Day/Year" order.
Set the time on a 12-hour basis.
The clock is maintained by the internal battery.
If you already set the time but the date/time setting
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact an
authorized SHARP servicing dealer or service center for
assistance with battery replacement.
Estimated service life of the internal battery: About 5
years (depending on monitor operation)
The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before
its expected operation life.
: :
12 : 00 AM
7
E