REMS Akku-LED-Lampe Notice D'installation Et D'utilisation Succincte page 11

NOTICE
Charge the battery before use. Recharge Li-Ion batteries regularly to avoid their total
discharge. The rechargeable battery will be damaged by total discharge.
Only use a REMS rapid charger for charging. New Li-Ion batteries and Li-Ion batteries which
have not been used for a long time only reach full capacity after several charges. Non-
rechargeable batteries may not be charged.
Rapid charger Li-ion/NiCd (Art. No. 571560)
The left control lamp lights up and remains green when the mains plug is plugged in. If a battery
is inserted in the rapid charger, the green control lamp flashes to indicate that the battery is
charging. The green light stops flashing and remains on to signal that the battery is fully charged.
If the red control lamp flashes, the battery is defective. If the red control lamp comes on and
remains on, this indicates that the temperature of the rapid charger and / or the battery is outside
the permissible operating range of the rapid charger of 0°C to +40°C.
NOTICE
The rapid chargers are not suitable for outdoor use
2.2. Mobile application
Hold the REMS cordless LED lamp by the handle (3), point the lamp head (1) at the place to
be illuminated. The lamp head (1) can be continuously swivelled by 145°.
2.3. Stationary application
Stand the REMS cordless LED lamp on the battery (4) or hang it up on a suitable device (5),
e.g. on a hook. Point the lamp head (1) at the place to be illuminated. The lamp head (1) can
be continuously swivelled by 145°.
3. Operation
Switch on the REMS cordless LED lamp by pressing the On/Off switch (2). Switch off the REMS
cordless LED lamp by pressing the On/Off switch (2) again.
Low discharge protection
The REMS cordless LED lamp is equipped with a low discharge protection. This switches the
REMS cordless LED lamp off as soon as the battery needs recharging. In this case, press the
On/Off switch (2) once, remove the battery and charger with the REMS rapid charger.
4. Maintenance
4.1. Maintenance
WARNING
Remove the battery before cleaning!
The REMS cordless LED lamp is maintenance-free.
Clean plastic parts (e.g. housing, plastic disc, batteries) only with the REMS CleanM machine
cleaner (Art. No. 140119) or a mild soap and a damp, soft cloth. Do not use household cleaners.
These often contain chemicals which can damage the plastic parts. Never use petrol, turpentine,
solvent or similar products for cleaning plastic parts.
Liquids may never be allowed to penetrate inside the REMS cordless LED lamp. Never immerse
the REMS cordless LED lamp in liquids.
1 2
eng
11