Publicité
Les langues disponibles
Les langues disponibles
LIPO battery charging (brushless version)
WARNING! The supplied LIPO battery is designed to be
charged with the supplied LIPO charger only. The sup-
plied LIPO charger is designed for charging the supplied
LIPO battery. Carefully read the instructions and war-
nings before charging the battery. Do not leave the bat-
tery and charger without supervision during the charge!
Do not leave the battery connected to the charger once
the charge process is complete. The charger is designed
to charge only one battery at a time, don't try to charge
two batteries simultaneously. Charging batteries carries
the risk of fire, property damage or injury.
The charger can charge 7.4V 2S or 11.1V 3S Lipo batte-
ries (11.1V 3S battery only with the 1/8 Shootout car).
The charger is designed for charging batteries equip-
ped with JST-XH type balancing connectors. Batteries
without any balancing connector or other balancing
connector types cannot be charged with this charger.
The charge process can last several hours depending
on the battery charge state. The charger automatically
stops the charge process when the battery is full.
Status LED function
The charger is equipped with three LED to monitor the
charger and battery status (one for each battery cell).
• Green = charger connected to power source and/or
battery charged
• Red = charging
• Flashing red = issue detected with the battery or char-
ger
WARNING! If the LED fail to light or if the LED flash RED,
disconnect the battery from the charger and the char-
ger from mains power. Discontinue use of the char-
ger and battery until you have resolved the issue, seek
assistance from your reseller if required.
44
INSTRUCTION MANUAL | MODE D'EMPLOI | BEDIENUNGSANLEITUNG
HIMOTO 1/18 OFF-ROAD CARS
LIPO battery charging procedure
1. Connect the power cord to the charger
2. Connect the power cord's plug into a 220/240VAC
mains power outlet, the green LED light.
3. Connect the battery JST-XH white balancing connec-
tor to the appropriate charge port, 7.4V 2S 3-pin or
11.1V 3S 4-pin.
4. Two (7.4V 2S battery ) or three (11.1V 3S battery)
LED light red, the battery is charging.
5. When the battery is full, the LED turn green again.
6. Disconnect the battery from the charger and dis-
connect the charger from mains power once the
charge is complete.
WARNING! Always charge batteries away from people
and flammable materials. If the battery becomes hot,
swells or vents immediately stop the charge process
and store the battery in a safe place, away from peo-
ple and flammable materials. If the internal contents of
the battery come into contact with your skin, wash the
affected area(s) with soap and water immediately. If it
comes into contact with your eye(s), flush them with
generous amounts of water for 15 minutes and seek
immediate medical attention.
HIMOTO 1/18 OFF-ROAD CARS
WWW.NEIDHART.COM | WWW.HIMOTO.CH
45
Publicité
