Himoto BUGGY E18XB Mode D'emploi page 20

Transmitter
6
1
2
Installing the batteries
The transmitter is powered using 4 AA
size 1.5V Alkaline batteries.
Install the batteries while respecting the
polarities.
1) Open the cover
38
INSTRUCTION MANUAL | MODE D'EMPLOI | BEDIENUNGSANLEITUNG
HIMOTO 1/18 OFF-ROAD CARS
1. Grip
2. Battery compartment
3. Steering Trim (CH1)
4. Steering travel
5. LED (ON/OFF, binding)
6. Steering wheel (CH1)
7. Throttle trigger (CH2)
8. Internal Antenna
9. Binding key
10. ON/OFF switch
11. Channel reverse switch for CH1
10
7
8
4
9 5
3) Close the cover
2) Insert the batteries
respecting the polarities
HIMOTO 1/18 OFF-ROAD CARS
Binding (Brushless)
The transmitter must be synchronised (binding) so that
they can communicate together. When you purchase
your RC model, the binding is already done. However
if the RC model does not respond to the transmitters
inputs, you can attempt to solve the issue by executing
the binding procedure.
Note: if there are interferences/glitches when respon-
ding to the transmitter inputs, this is not a binding issue.
1. Make sure all components are properly connected
(see page 11).
2. Position the RC model so that the wheels are not on
the ground. This way if the wheels start spinning the
RC model will not run away.
3. Switch the transmitter ON, the red LED flashes.
4. Connect the battery to the ESC.
Binding (Brushed)
The transmitter and receiver must be synchronised (bin-
ding) so that they can communicate together. When you
11
purchase your RC model, the binding is already done.
However if the RC model does not respond to the trans-
mitters inputs, you can attempt to solve the issue by
executing the binding procedure.
Note: if there are interferences/glitches when respon-
ding to the transmitter inputs, this is not a binding issue.
1. Make sure all components are properly connected.
2. Position the RC model so that the wheels are not on
the ground. This way if the wheels start spinning the
RC model will not run away.
3
WWW.NEIDHART.COM | WWW.HIMOTO.CH
5. Press the SETUP key on the receiver while swit-
ching ON the ESC. The receiver's LED flashes. After 1
second, release the button.
6. Press the BIND key on the transmitter until the
transmitter red LED lits permanently.
7. The transmitter red LED being permanently lit indi-
cates that the binding was successful. In case of
error, the LED stays off or flashes.
3. Switch the transmitter ON by holding the Binding
key on the same time. The red LED on the transmit-
ter flashes.
4. Connect the battery to the ESC.
5. Turn on the ESC.
6. The binding is done right now. You can verify by
moving the steering wheel to see if they move.
7. Turn off the ESC, then the transmitter.
8. Binding procedure is finished now.
39