Building-In - Kuppersbusch IKE 160-2T Instructions De Montage Et D'emploi

GB
Attention!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.

Building-in

Dimensions of the recess
Height of housing (1)
880
Depth of housing (2)
550
Width of housing (3)
560
It is necessary that the niche is provided with a
conduct of ventilation
dimensions:
Depth 50 mm
Width 540 mm
For appropriate venting, follow indications in the
figure.
24
1225 mm
550 mm
560 mm
having the following
1. Fit the appliance in the niche by making sure that it
stands against the interior surface of the unit on the
side where the door hinges of the appliances are
fitted. Insert the appliance until the upper strip
butts up against the unit (1) and make sure that the
lower hinge is in line with the surface of the unit (2).
2. Open the door and push the appliance against the
side of kitchen furniture opposite to that of the
appliance hinges. Fasten the appliance with 4 screws
(I) provided in the kit included with the appliance.
3. Press in the joint covers between the appliance
and the kitchen furniture.