Publicité
Les langues disponibles
Les langues disponibles
3.
Lower the handle and align the cutting line with
the saw blade.
4.
Return the handle to the original position and
secure the workpiece with the vertical vise so that the
workpiece does not move from the position you have
determined.
5.
Install the batteries and turn on the laser switch.
6.
Loosen the adjusting screw. To move the laser line
away from the blade, turn the range adjustment screws
counterclockwise. To move the laser line close to the
blade, turn the range adjustment screw clockwise.
Adjusting the laser line on the left side of the blade
► 1. Adjusting screw 2. Range adjustment screw
3. Hex wrench 4. Laser line 5. Saw blade
Adjusting the laser line on the right side of the blade
1
2
3
► 1. Adjusting screw 2. Range adjustment screw
5
7.
laser line comes onto the cutting line and then tighten.
NOTE: The movable range of laser line is factory
adjusted within 1 mm (0.04") from the side surface
of blade.
Cleaning the laser light lens
For DLS111, DLS112 only
The laser light becomes hard to see as the lens for the laser
light gets dirty. Clean the lens for laser light periodically.
► 1. Screw 2. Lens
Remove the batteries. Loosen the screw and pull out
the lens. Clean the lens gently with a damp soft cloth.
NOTICE:
secures the lens. If the lens does not come out,
loosen the screw further.
NOTICE:
leum-based cleaners on the lens.
39 ENGLISH
1
2
3
5
3. Hex wrench 4. Laser line 5. Saw blade
Slide the adjusting screw to the position that the
1
2
Do not remove the screw which
Do not use solvents or any petro-
4
Publicité
