Publicité
Les langues disponibles
Les langues disponibles
Installing or removing wheel guard
(For depressed center wheel, multi disc /
abrasive cut-off wheel, diamond wheel)
WARNING:
When
using
a
•
wheel/Multi-disc, flex wheel, wire wheel brush, cut-
off wheel or diamond wheel, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
For tool with clamp lever type wheel guard
1
2
015084
Loosen the lever on the wheel guard after loosening the
screw. Mount the wheel guard with the protrusion on the
wheel guard band aligned with the notch on the bearing
box. Then rotate the wheel guard to such an angle that
it can protect the operator according to work.
2
1
015085
Tighten the lever to fasten the wheel guard. If the lever
is too tight or too loose to fasten the wheel guard,
loosen or tighten the screw to adjust the tightening of
the wheel guard band.
To
remove
wheel
procedure in reverse.
depressed
center
1. Wheel guard
2. Bearing box
3. Screw
4. Lever
3
4
1. Screw
2. Lever
3. Wheel guard
3
guard,
follow
the
For tool with locking screw type wheel guard
grinding
1
2
015303
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard to such an angle that it can
protect the operator according to work. Be sure to
tighten the screw securely.
To
remove
procedure in reverse.
Installing or removing depressed center
wheel or multi disc (optional accessory)
WARNING:
When using a depressed center wheel or multi disc, the
•
wheel guard must be fitted on the tool so that the closed
side of the guard always points toward the operator.
Only actuate the shaft lock when the spindle is not
•
moving.
015310
Mount the inner flange onto the spindle.
Make sure to fit the dented part of the inner flange onto
the straight part at the bottom of the spindle.
Fit the wheel/disc on the inner flange and screw the lock
nut onto the spindle.
installation
1
2
015311
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
9
1. Wheel guard
2. Bearing box
3. Screw
3
wheel
guard,
follow
1. Lock nut
1
2. Depressed
2
3. Inner flange
3
1. Lock nut
2. Shaft lock
the
installation
center wheel
wrench
Publicité
