Reverse Button; Grip - Makita XRU09 Manuel D'instruction

To start the tool, grasp the rear handle (the lock-off lever
is released by the grasp) and then pull the switch trigger.
To stop the tool, release the switch trigger.
NOTE:
The tool is automatically turned off after the tool is
•
left one minute without any operations.
Speed adjusting
1
015790
You can adjust the tool speed by tapping the main
power button.
Each time you tap the main power button,
or indicator lights up.
for low speed.
Reverse button for debris removal
WARNING:
Switch off the tool and remove the battery cartridge
•
before you remove entangled weeds or debris which
the reverse rotation function can not remove. Failure
to switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
015791
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris
entangled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
NOTE:
During the reverse rotation, the tool operates only for
•
a short period of time and then automatically stops.
1. Main power
button
indicator
is for high speed and

1. Reverse button

1
Once the tool is stopped, the rotation returns to
•
regular direction when you start the tool again.
If you tap the reverse button while the tool's head
•
is still rotating, the tool comes to stop and to be
ready for reverse rotation.
Nylon cutting head (optional accessory)
NOTICE:
The bump feed will not operate properly if the
•
head is not rotating.
1
015788
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance" .
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the grip
2
3
4
015390
9
1. Most effective
cutting area

1. Grip

1
2. Hex bolt
3. Cover
4. Clamp
5. Hanger
5