Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented
for installation and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation
and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Standard Floodlamp follow the instructions provided below:
1. VERIFY THE CONTENTS OF THE PACKING:
The following accessories are included inside the box:
Housing body
2 watertight joints
Clamp
Floodlamp unit
Bag of screws:
(1) For floodlamps with metric pitch housing
2. GENERAL CHARACTERISTICS:
This floodlamp has been designed to be used fully submerged underwater in fresh water swimming pools. It is a Class
III electric apparatus with very low safety voltage (12V with alternating current).
The floodlamp compiles with IPX8 degree of protection (resistance to penetration of dust, solid bodies and humidity)
at a nominal immersion depth of 2 m.
This floodlamp compiles with international safety standards for lights, especially the EN 60598-2-18 standard.
LIGHTS PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR
APPLICATIONS.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handied at locations other than its own premises.
3. INSTALLATION:
•
Never install the lamp facing downwards,
•
In order to clearly light a pool it is recommended lo install a 300W floodlamp every 25 or 35 m² of water surface.
In swimming pools which are especially deep, a 300 W floodlamp is required for every 30 or 40 m³ of water
volume.
•
In order to prevent glare, the floodlamps should be installed so that they face away from the residence or usual
view of the swimming pool.
•
In the event that lighting is used in training or competition pools, the floodlamps should be installed on the sides
to prevent glare on the swimmers.
•
To avoid the need to empty the pool to change the lamp, we recommend that the floodlamp be installed in areas
which are accessible from the upper edge of the pool.
Prior to installation verify that the gland seal (no. 16) has been fully tightened.
The floodlamp should be placed on the wall of the pool at approximately 400-700 mm from the water surface (Fig.
1).
To place a projector in a prefabricated swimming pool, which can be either metal plate or plastic, make a circular
hole measuring 276 mm. in diameter and 8 holes measuring 4.5 mm. (Fig. 2)
Place the recess (no. 17) through the inside part of the swimming pool and bolt the 8 DIN 7982 4.8x25 screws (no.
28) (Fig. 3). Make sure that the cable comes out of the recess through the upper part.
Stick one of the adhesive seals (no. 23) on the inside of the pool and then place the liner.
Place the other adhesive seal and then the flange (no. 24) inside the pool. Fasten the flange (no. 24) in the recess
(no. 17) with 16 DIN 7982 5.5x25 screws (no. 25), 16 DIN 966 M-6x24 screws (no. 25).
Cut the Liner remaining inside the flange so that the recess is clear and then assemble the projector.
2 DIN 7981 A2 4,8x16 screws
16 DIN 7982 A2 5,5x25 screws
16 DIN 966 A2 M-6x24 screws (1)
8 DIN 7982 A2 M-4,8x25 screws
Publicité
