Inserting/Changing The Batteries - VOLTCRAFT LSG-4 DMM Notice D'emploi

INSERTING/CHANGING THE BATTERIES

The multimeter requires two AAA batteries for operation. You need to insert new, charged batteries prior
to initial operation or when the battery change symbol
The signal transmitter requires a )V compound battery just like the receiver. You need to change the bat-
tery when the display "L2" is lit or if there is no audible sound on the receiver.
To insert/replace the batteries in the DMM, proceed as follows:
- Disconnect the measuring device from all measuring circuits
and turn it off.
- Remove the protective rubber frame (12) from the device.
- Undo the screws on the battery compartment cover (11) and
remove the cover.
- Place new batteries into the battery compartment observing
the correct polarity.
- Now close the housing carefully again.
To insert/replace the batteries in the receiver, proceed as follows:
- Turn the device off with the rotary switch (20).
- Undo the screw of the battery compartment cover (18) and
remove the cover.
- Place a new battery into the battery compartment, observing
the correct polarity.
- Now close the housing carefully again.
Never operate the devices when they are open. !RISK OF FATAL INJURY!
Do not leave flat batteries in the device. Even batteries protected against leaking can
corrode and thus release chemicals which may be detrimental to your health or
destroy the battery compartment.
Do not leave batteries lying around carelessly. They might be swallowed by children
or pets. If swallowed, consult a doctor immediately.
If the device is not used for longer periods of time, remove the batteries in order to
prevent leaking.
Leaking or damaged batteries might cause acid burns when getting into contact with
skin. Therefore, use suitable protective gloves.
Make sure that the batteries are not short-circuited. Do not throw batteries into fire!
Batteries may not be recharged or dismantled. Danger of explosion.
36
appears on the display.