Hitachi Koki C 10RA3 Mode D'emploi page 13

WARNING
Improper splitter alignment can cause "kickback"
and serious injury
Fig. I
Anti-kickback Pawl
9
ADJUSTING THE 90°(0 ) AND 45° POSITIVE STOPS
0
(FIG. J, K, L)
Your saw has positive stops that will quickly position
the saw blade at 90°(0 ) and 45
0
adjustments only if necessary.
90°(0 ) Stop
0
1. Disconnect the saw from the power source.
2. Turn the blade elevation handwheel and raise the
blade to the maximum elevation.
3. Loosen the blade bevel lock knob (1) and move the
blade to the maximum vertical position, then tighten
the lock knob (1).
4. Place a combination square on the table and against
the blade (2) to determine if the blade is 90°(0
the table. (Fig. K)
5. If the blade is not 90°(0
set screws (4), located on the collar (5) underneath
the table saw (Fig. L) with the hex key, and back off
the collar.
6. Loosen the bevel lock knob, turn the blade tilting
handwheel to move the blade until it is 90°(0
table and tighten the bevel lock knob.
7. Adjust the collar (5) so it contacts the bracket (3)
when the blade is 90°(0
two set screws (4). (Fig.L)
Fig. J
8
10
Straight edge
to the table. Make
0
) to
0
0 ) to the table, loosen the two
) to the
0
) to the table. Tighten the
0
1
Fig. K
90 (0
0
45° Stop
1. With the blade in the upright 90°(0
the bevel lock knob and move the blade to the
maximum bevel angle.
2. Place the combination square on the table as shown
in Fig. K to check if the blade is 45° to the table.
3. If the blade is not 45° to the table, loosen the two set
screws (4), located on the collar (5) nuderneath the
table saw, with the hex key, and back off the collar.
(Fig. L)
4. Loosen the bevel lock knob, turn the blade tilting
handwheel to move the blade until it is 45° to the table
and tighten the blade bevel lock knob.
5. Adjust the collar (5) so it contacts the bracket (3)
when the blade is 45° to the table. Tighten the two
set screws.
BLADE TILT POINTER
1. When the blade is positioned at 90°(0
blade tilt pointer to read 0° on the scale.
2. Loosen the mounting screw, position pointer over
0° and tighten the screw.
NOTE: Make a trial cut on scrap wood before making
critical cuts. Measure for exactness.
Fig. L
4
5
– 13 –
45 0
)
0
2
) position, loosen
0
), adjust the
0
3
45
0
3
4
90 (0
0
5
English
)
0