Optional Rear Filler - LG LSSE3026ST Manuel D'utilisation

Optional rear Filler

If the counter does not bridge the opening at the rear
wall the rear filler kit, that is provided with the slide in
range, will be needed.
NOTE
If the countertop depth is greater than 25" there
will be a gap between the filler kit and the back
wall.
If the countertop depth is less than 24", the control
panel will not sit flush with the countertop.
IInstalling the rear Filler
1
Using a screwdriver, remove the six screws
holding the rear bracket in place and remove the
bracket.
2
Attach the rear filler to the range back, sliding
the hooks into the slots as shown. Slide the rear
bracket into the bottom opening in the rear filler.
Rear bracket
Remove
Rear filler
hook
3
Attach the rear bracket and filler assembly as
shown, using four of the six screws removed in
step 1.
4
Store the remaining two screws with these
instructions for future use.
Test run
Check if the range is properly installed and run a test
cycle.
1
Turn the oven mode knob to the Off position to
start test.
2
Turn each knob to the Hi position to check
that the surface heating elements are working
properly. The elements should glow red and
radiate heat, and they should cycle on and off
periodically even when the knob is in the Hi
position. This cycling prevents the glass-ceramic
from being cracked by thermal shock.
IMPOrTaNT : The Warming Zone does not
consume enough power to glow red.
3
After checking all the surface heating elements,
check the locking system by pressing Probe
for three seconds. The oven door should lock
and the cooktop should not operate while the
Lockout function is turned on. Pressing Probe
for three seconds to disable Lockout.
4
Now check the oven's operation. Turn the oven
mode knob to select the Bake mode. 350 °F
appears in the display. Press Start.
5
The oven should finish preheating in 15 minutes,
and the convection fan should operate while the
oven is preheating.
6
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven on
for at least an hour to help remove any oil which
might cause smoke and odors when first using
the oven.
NOTE
Smoke may come out of the range when it is first
used.
INSTALLATION 15
Slot
Lower screws