AXXAIR SAXX-210 Mode D'emploi page 70

INNOVATIVE ORBITAL SOLUTIONS
Weld / Test / dynamic :
Join experience
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
After choosing program, this screen shows
you the information recap.
Check that programed
corresponds to connected machine.
If all information are ok, press the:
- Gaz/electrode button to access
necessaries adjustment screen
- right arrow to access directly to the
weld starting screen
This screen displays all information about
electrode and arc length so as you can
adjust your machine as specified.
If you use a closed head, 3 buttons allow
you an easy positionning for electrode
change in funtion of electrode diameter.
Gas line adjustment:
Start gas line and adjust flow according to the
programmed value.
By default, minimum is 4 l/min for torch and 1
l/min for inside gas. Maximum is 50 l/min. If
you have choosen to activate gas alarm on
the menu adjustment/welding, you will see
the tolerated percentage.
If the second line gas is activated, you have
to adjust both line gas.
Delay of 90s stops gas if you forget to stop it.
Access to next screen only possible if green
indicator is illuminated (except in test mode).
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 70 -
English
machine