AXXAIR SAXX-210 Mode D'emploi page 65

INNOVATIVE ORBITAL SOLUTIONS
Copy :
Erase :
Print :
Join experience
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Select the program you want to copy.
Program is blinking, now select an empty
place to copy it.
Press on the program number if you want
to erase basis information and all programs
of this screen.
Or just select the program you want to
erase.
Then validate by pressing 2s the erase
button:
If you print from the welding screen, you can
choose between program and real parameters.
Real parameters will print only the last measured
value of each welding phase. Real welding energy
is calculated with the same formula than programed
value but it takes in account real voltage instead of
theoretical voltage, that is why real welding energy
can be diffenret that theoretical.
You have two lines for adding a note if you want.
Check that the paper is well positionned into the
printer (paper end must be outside the printer) and
then press the "print" button.
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 65 -
English