AXXAIR SAXX-210 Mode D'emploi page 61

INNOVATIVE ORBITAL SOLUTIONS
If mode « tacking auto » :
If mode « tacking auto » :
If OSC mode :
Join experience
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Choice between 4 and 8 tacks.
Tack parameters:
Tacking pregas: After moving, the machine
stays at the same place during this pregas
time before tacking.
Preheating: Current is the same for orbital
welding but time can be different.
Tacking time: currents and pulse times will
be used during this time. You can choose
to pulse or to have a constant current by
pressing the button "Current".
Tacking postgas:
After a tacking, the machine stays at the
same place during this postgas time before
moving to the next tacking.
The start angle is the angle between the
last tacking and the beginning of the orbital
welding.
The moving time is the time for the
electrode to cover the oscillation stroke.
The electrode goes from one side to
another (moving time), then stop (stop
time), and then goes to the other side
(moving time).
« Synchronize current
oscillation »: When you choose this option,
you can not modify high and low pulse time
because they are automatically put equals
to moving time and stop time. High current
will be activated only during stop time and
low current will be activated only during
moving time. If you do not choose this
option, current will be pulsed independantly
from the electrode position.
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 61 -
English
pulse with