Setting The Sound - Harman JBL DSP2544 DSP Mode D'emploi

SETTING THE SOUND

Download the tuning software from JBL.com
1. Connect to internet with your Windows PC or laptop and go
to JBL.comxxxx and download the Graphic User Interface for
the DSP2544 Amplifier.
2. Complete the software installation setup wizard before you
connect your computer to your JBL DSP Amplifier.
3. Double-click "JBL DSP software" from its saved location.
4. Double-click "USB driver" and click install.
NOTE: Make sure to allow it to make changes to your computer if
your anti-virus software requests it.
5. Double-click "setup.exe".
NOTE: Make sure to allow it to make changes to your computer if
your anti-virus software requests it.
6. Click "Next" in the JBL DSP Software Setup Wizard.
7. Select preferred installation folder, or click "next" to choose
the default location.
8. Click "Next" to confirm installation. Again, make sure that your
anti-virus protection allows installation to be completed.
9. Sit back and wait while software installation completes...
CA_JBL_DSP Amplifier DSP2544_QSG_SOP_V5.indd 4 CA_JBL_DSP Amplifier DSP2544_QSG_SOP_V5.indd 4
JBL DSP2544 DSP Amplifier
10. Installation Complete! Close setup wizard and continue to
next section. You should see this icon on your computer
screen (please note to icon is JBL orange).
Connecting JBL DSP Amplifier to your Windows PC
1. Connect your Windows PC to the DSP2544 with the included
USB cable.
2. Make sure to turn your audio source down to a low
volume level before powering your JBL DSP Amplifier.
3. Activate/power your audio system and make sure all parts
are operating.
NOTE: The DSP2544 will come with pre-flashed EQ profile that will
act as "EQ Off" or preset 1.
4. With your PC connected to the JBL DSP Amplifier, double-click
JBL software icon on your PC and open DSP tuning software.
NOTE: If the software appears with a window showing "No Comm
Port Available", close the software, disconnect the USB cable from
your computer, and return to step 4. Otherwise, proceed to step 5.
The DSP software will function when not connected to the amplifier
if you would like to familiarize yourself with the software and create
a pre-configured audio system setup.
5. Connection complete! Continue on to Tuning Procedure...
OUTPUT INPUT PWR
R R R R F F R R G
REMOTE TURN-ON INPUT PC R R L L R L L R N
+ - + - - - - -
D
MODE LEVEL
CH 1- 4 LOW IN
REM DC AUDIO LOW HI
F F F F F F R R O
L L R R R L L R U
+ - + - + + + +
T
CH 5-6 PRE-OUT OUTPUT INPUT REM
9/28/2020 2:13:02 PM 9/28/2020 2:13:02 PM
EN
B
A
T
PRT
PWR
I
N