Mains Connection; Dust Collection; Starting Operation; Machine Operation - Jet JWL-1440VS Mode D'emploi

Top surfaces and inside ways must be flush to allow smooth
movement of tailstock.
Slide tailstock over joint where beds meet, so that clamping
nut is centred over joint. Lock tailstock clamping handle; this
will align the beds.
Securely tighten screws (P) in bed extension.

5.3 Mains connection

Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.

5.4 Dust collection

Use a suitable dust collection and filtration system to avoid a
high dust concentrations in the air.

5.5 Starting operation

You can start the machine with the green ON-button. The red
OFF-button on the main switch (B, Fig 1) stops the machine.

6. Machine operation

6.1 Correct operating position

Always support the tool on the tool rest and guide with the
palm of your hand keeping your fingers closed.
(see Fig 11 and 12)
Fig 10

6.2 Tool selection:

Successful wood turning does not result from high speeds,
but rather, from the correct use of turning tools.
A perfect and sharp wood turner tool is a precondition for
professional wood-turning.
Major tools:
Gouge (A, Fig 13), used for rapidly cut raw wood into round
stock, for turning bowls and plates, for turning beds, coves
and other detail (Fig 14).
Fig 11
Fig 12
Fig 13