Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Reinstall the headstock covers.
8.3 Changing belt and bearings
Changing belt and bearings can be a difficult task. Remove
headstock and take into a repair station for servicing.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Workpiece is not properly centred-
*The speed is too high-
Tailstock moves
*Cam lock nut needs adjusting-
Tighten cam lock nut.
*Bed and tailstock mating surfaces greasy or oily-
Remove tailstock and clean surfaces
*Excessive pressure applied-
Slide tailstock to right side of lathe against stop (N, Fig 10).
Move headstock into position and then apply pressure.
Fig 35
Fig 36
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.
11. Available accessories
Stock number 719402
Cast iron legs with levelling feet
Stock number 719401
Bed extension 508mm with tool post extension
Stock number 719001
Tailstock swing away
Stock number 708331
Live centre MT2
Stock number 708343K
Drill chuck 13 mm, with tapered mandrel MT-2
Stock number 709911
Face plate 75mm, M33x3,5
Stock number 709942
Four toothed spur centre MT-2
Stock number 708332
Face shield
Refer to the JET-Pricelist
for various tools and work holding.
Publicité
Chapitres
Table des Matières
