Remaining Hazards; Machine Specifications; Machine Description; Technical Data - Jet JWL-1440VS Mode D'emploi

When sanding, remove the tool rest from the machine.
Workpieces with cracks may not be used.
Remove the chuck key or dowel pins before turning the
machine on.
Always close the belt cover.
Specifications regarding the maximum or minimum size of the
workpiece must be observed.
Test each set-up by revolving the work by hand to insure it
clears the tool rest and bed. Check setup at the lowest speed
before you increase to the operating speed.
Do not remove chips and workpiece parts until the machine is
at a standstill.
Never stop work pieces with the hand during run out.
Do not attempt to engage the spindle lock pin until the spindle
has stopped.
Never take measurements on a rotating workpiece.
Do not stand on the machine.
Connection and repair work on the electrical installation may
be carried out by a qualified electrician only.
Have a damaged or worn power cord replaced immediately.
Make all machine adjustments or maintenance with the
machine unplugged from the power source.

3.3 Remaining hazards

When using the machine according to regulations some
remaining hazards may still exist.
The rotating workpiece can cause injury.
Workpieces that are inhomogeneous or weak can explode
when being processed due to centrifugal force.
Only process selected woods without defects.
Unbalanced workpieces can be hazardous.
Injuries can occur when feeding tooling, if tool supports are
not correctly adjusted or if turning tools are blunt.
Risk of kickback. The tooling is caught by the rotating
workpiece and thrown back to the operator.
Thrown workpieces and workpiece parts can lead to injury.
Dust and noise can be health hazards. Be sure to wear
personal protection gear such as safety goggles and dust
mask. Use a suitable dust collection system.
The use of incorrect mains supply or a damaged power cord
can lead to injuries caused by electricity.

4. Machine specifications

4.1 Machine description

A Head stock slide/swivel lock handle
B Main ON/OFF switch
C Spindle lock
D 300mm tool rest
E Tool rest base
F Machine bed
G Live centre
H Tailstock lock handle
I Tailstock hand wheel
J Levelling feet (optional)
K Cast iron legs (optional)
L Head stock swivel index
M Speed control knob, speed display

4.2 Technical data

Swing over bed
Centre distance
Spindle speed range
Headstock spindle nose
Headstock spindle taper
Spindle index lock
Headstock rotation 0°, 30°, 60°, 90°,120°, 180°, 270
Tailstock spindle taper
Tailstock hole diameter
Tailstock ram travel
Centre above floor
Overall, lathe only (LxWxH)
Net weight
Overall, with leg stand (LxWxH)
Net weight
Fig 1
370mm
1016mm
350-2500 rpm
M33x3.5
MT 2
36 x 10°
MT 2
9mm
108mm
1120mm
1880x460x460mm
100 kg
1880x460x1250mm
165 kg