Cleaning The Brewing Unit (Figure G) - Siemens TE6 Série Mode D'emploi

● Remove the milk system 4b by pulling it
straight forward.
● Take apart the upper and lower parts of
the milk system 4b.
● Separate the milk tube from the suction
pipe.
● Clean the individual parts with washing-
up liquid and a soft cloth.
● Rinse all parts with clean water and dry
them.
F
The upper and lower parts of the milk
system 4b, the milk tube 4c and the
suction pipe 4d can also be cleaned
in a dishwasher.
● Reassemble the individual parts.
● Place the milk system 4b back in the
appliance from the front, making sure it is
straight.
● Replace the cover 4a.
Care and daily cleaning
Cleaning the brewing unit
(Figure G)
F
See also the Quick reference guide in
the storage compartment 16.
In addition to the automatic cleaning
programme, the brewing unit 14 should be
removed regularly for cleaning.
● Use the main switch J 1 to switch the
appliance completely off.
● Open the door 13 to the brewing unit.
● Slide the red latch 14a on the brewing
unit 14 all the way to the left.
● Press the eject lever 15 right down. The
brewing unit will be released.
● Take hold of the brewing unit 14 by the
recessed grips and carefully remove it.
F
Important: Clean it without using
washing-up liquid and do not put it in
the dishwasher.
● Remove the cover 14b and thoroughly
clean the brewing unit 14 under running
water.
● Thoroughly clean the strainer of the
brewing unit under the water jet.
en
41