Fritel BBQ 3256 Mode D'emploi page 17

• Leave at least 0,5 m free space around the appliance and 1 m free height in order to avoid damage caused by grease
splashes or heat and in order to work unhindered.
2. ASSEMBLY OF THE APPLIANCE
When assembling the appliance, make sure the power cord is unplugged.
a) Baking plate
For a safe use, it is very important that the plate is correctly placed on the grill holder.
• Take the baking plate by both handles
• Place the baking tray with the power inlet socket into the provided opening on the grill holder.
• To remove the baking plate again, simply lift it up and pull it out of the opening.
CAUTION: Only remove the baking plate when it has entirely cooled off or place it on a heat-resistant table mat.
TIP: The device can be used both as a table grill and as a BBQ (see point e) The support frame).
b) The grease collecting tray
Place the grease collecting tray in the frame. The appliance may NEVER be used without grease collecting tray.
c) The power inlet socket
Plug the supplied power cord into the power inlet socket and connect the other end to the socket.
d) The removable lid
For outdoor use or for dust free storage, the removable lid can be used. To this end, first screw the handle onto the
cover using the supplied screws and washers (see Fig. 1).
Fig. 1
e) The support frame
The grill can also be used on the support frame as a bbq appliance. This must be mounted as follows:
• Put the support frame and the shelf for platters upside down on top of each other (see Fig. 2).
• Insert the legs on the 4 sides through the provided openings and turn the legs (the beveled part facing outwards)
until they click into the support frame by means of the fastening pin (see Fig. 2 & 3).
• Put the whole frame into its correct position and push the shelf down to the desired height (see Fig. 4).
• Place the grill holder on the support frame.
CAUTION: make sure the appliance is securely mounted on the support frame before plugging in.
17