Numatic TTV 5565 Mode D'emploi Utilisateur page 40

!
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE DISENGAGING BRAKE
ARM. NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
The TTV 5565 is equipped with a free-wheel function that will enable the operator to move the machine manually if required.
41
42
43
!
WHEN THE BRAKE IS DISENGAGED THE MACHINE IS IN FREE-WHEEL MODE
Note: None of the other functions on the machine will work whilst in the free-wheel mode.
Remember to re-engage the drive when you reach your final destination / before using the
Free-wheel Function
The motor brake is located on the left side of the machine near the rear
wheel (see Fig.41).
Pull the arm out (see Fig.42).
Swing to the disengaged position (see Fig.43).
The motor brake will be fully disengaged.
The machine will now be in full free-wheel mode.
WARNING!
AND HAS NO BRAKE FACILITY.
40
!
!
machine..