Numatic TTV 5565 Mode D'emploi Utilisateur page 36

Breakaway Floor-tool
36
The floor-tool design incorporates a breakaway feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction, during forward machine
movement. (See Fig.36)
To re-attach the blade to its holder. First loosen the retaining knobs on the floor-tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight. (See Fig.37)
!
38
Machine Operation
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
Machine Usage Advice
To operate, turn the main control on / off key to position '1', select
water-flow rate, chemical mix (see page 28), lower the floor-tool
(see page 30) and select forward (see page 20), press the
start / stop trigger.
Vacuum pick-up, water-flow and chemical-dose will turn on automatically
and the machine will move forward.
Adjust the speed to suit the conditions using the variable speed control
(see page 20).
The clean-water / chemical mix is dispersed evenly via the 'THRU- FEED'
scrubbing brushes.
The waste-water is then retrieved by the suction floor-tool.
Overlap each scrubbing path by 10 cm to ensure an even clean.
Do not operate the machine on inclines that exceed (9%), when full.
If streaking occurs wipe floor-tool blades clean (see Fig.38).
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow
the chemical time to work then scrub the area a second time with the
floor-tool lowered.
37
Note: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles
36
!