Numatic TTV 5565 Mode D'emploi Utilisateur page 22

!
Setting the width adjustment
Adjustment of the brush deck must take place with the deck in the raised position.
Lift the deck locking knob located at the front of the machine. (see Fig.9), then pull the side pod at the handle position to
expand or close to contract the deck to the desired width - 650 mm (see Fig.10) or 550 mm (see Fig.11).
9
Owning the TTV 5565 scrubber dryer is like having 2 machines in one.
With two width-settings the operator can quickly adapt the machine to any cleaning situation;
without the need for any tools. The machine can be set to clean anything from a narrow corridor to a large
warehouse. The TTV 5565 is a totally versatile machine (see Fig.12).
Fitting the Brushes
13
2 x 330 mm Brush for 650 mm setting. 2 x 280 mm Brush for 550 mm setting.
Featuring the new OBS (Octagonal Brush System);
The brushes simply push-fit up onto the chucks making
fitting and removal a simple process.
Ensure the brush deck is set to the appropriate width for the brushes being used (Fig.10 / 11).
Slide the brush under the brush deck (Fig.13).
Fit the brushes onto the OBS drive chuck (Fig.14).
Safety gloves are recommended for the changing of used brushes.
Note: Check the deck width setting is correct with the selected brushes before use.
Machine Set-Up
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Note:
10
650 mm
Note: Use 2 x 330 mm Brush size for
650 mm setting.
14
Remove the brushes before adjusting width.
650mm
22
11
550 mm
Note: Use 2 x 280 mm Brush size for
550 mm setting.
550mm
12
!