DeWalt DCR015 Guide D'utilisation page 10

TO INSTALL COIN CELL BATTERY (FIG. 3)
WARNING: Danger of explosion if battery is incorrectly replaced.
When replacing battery, replace it with the same or equivalent type
CR2032. Observe correct polarity (+ and –) when replacing batteries.
Do not store or carry batteries so that metal objects can contact
exposed battery terminals.
1. Open the battery compartment
by lifting the battery
compartment latch.
2. Turn the screw on the battery
door (M) counterclockwise
to remove. Screw will remain
captive in the door.
3. Press down on the battery door
latch and pull to open.
4. Install the coin cell battery (N) according to the diagram inside the
coin cell battery area.
5. Replace the battery door, insert the screw and tighten.
6. Securely close the battery compartment.
NOTE: To reset the LCD display, clock, and pre-sets remove the coin
cell battery and re-install. Follow this procedure if the screen seems
to lock in place.
DANGER: DO NOT INGEST BATTERY; CHEMICAL BURN
HAZARD. This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery
compartment does not close securely stop using the product
and keep it away from children
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.
FIG. 3
L
N
M
8
CHARGER SELECTION SWITCH (FIG. 3, 4)
When the unit is plugged into an AC power
outlet, this switch (L), located in the battery
compartment, allows you to set the device
to its lowest power consuming state
(charger only) by disabling the radio.
Aligning the line to the triangle enables the
charger/radio mode.
Aligning circle and the triangle disables the
radio and turns device to its lowest power draw mode, charger only.
NOTE: When the unit is operating solely on battery power, the radio
will continue to function in either mode.
POWER/VOLUME ADJUSTMENT
1. To turn the radio on and off, press the ON/OFF button (A).
2. Turn the dial (B) clockwise to increase the volume. To decrease
the volume, turn counterclockwise.
MODE FUNCTION
To choose one of the mode functions (FM1, FM2, AM, or AUX) push
the mode button (F) until the desired function is found. For example, if
the radio is on FM1, seen in upper left portion of LCD display (J), push
the mode button three times to change to AUX.
TUNE OR SEEK FUNCTION
There are two tuning methods and one seek method for finding the
desired frequency.
To tune:
Press and hold the right or left arrow button (E) to quickly move the
tuner through the frequency band. Release the button when the
desired channel is reached.
FIG. 4
CHARGER/ CHARGER
RADIO ONLY