Publicité
Les langues disponibles
Les langues disponibles
3
Install any internal options
A
If you have options to install, install them now.
1. Unlock doors.
2. Unlock side panels.
3. Remove side panels.
4. Install options.
Refer to the following chapters in the System Reference
manual for detailed information.
Server Software and Utilities
Processor Module Upgrades
Installing Additional Memory
Installing Disk and Tape Drives
Connecting SCSI and RAID Adapters
Also, refer to the documentation that came with the option
kit for specific installation instructions.
Installation Guide
CAUTION
Removing the side panels activates the power
interlock switches. These switches turn off power
to your server. You might injure yourself or
damage the server if you attempt to override or
bypass these switches. Always replace the side
panels before you turn on power to the server.
Before touching any circuit board or component,
wear an anti-static wrist strap, properly grounded
to the server chassis, or touch the metal frame to
discharge any static electricity.
NOTES
Use the brake located at the bottom of your server
lock your server in place.
ISA cards should be installed after you run the System
Configuration Utility in Step 7 or 8 since the SCU will list
IRQs already used.
If you plan to use Quick Launch to install your Network
Operating System, your server must meet the following
minimum requirements to proceed with the server installa-
tion:
16 MB of RAM
SVGA monitor
540 MB minimum hard disk drive
Two or three button mouse
CD-ROM drive with boot capability attached to the
bootable SCSI controller
Keyboard
to
A
5
Publicité
