Bosch EasyRotak 36-550 Notice Originale page 18

18 | English
Noise/Vibration Information
Noise emission values determined according to EN 60335-2-77.
Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Sound power level
– Uncertainty K
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 60335-2-77
– Vibration emission value a
h
– Uncertainty K
Mounting and Operation
Action
A)
Delivery scope
Mounting wheels
Mounting the handle
Adjusting the working height
Snap together the Grassbox
Grassbox fitting/removing
Setting the height of cut
Inserting the battery
Operation
- Inserting the isolator switch
- Switching on
- Mowing
- Switching off
- Removing the isolator switch
Removing the battery
Working advice "mowing"
Blade maintenance/Blade replacement
Selecting accessories
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Starting Operation
For Your Safety
Warning! Switch off, remove the isolator switch and
u
the battery before adjusting or cleaning. The same ap-
plies when the cable to the switch in the handle is
damaged, cut or entangled.
The blade continues to rotate for a few seconds after
u
the machine is switched off.
Caution: Do not touch the rotating blade.
u
F 016 L81 912 | (06.02.2020)
dB(A)
dB(A)
dB
2
m/s
2
m/s
Charging the Battery
The battery is equipped with temperature monitoring that al-
Figure Page
lows charging only in the temperature range between 0 °C
and 35 °C. In this manner, a high battery service life is
A 314
achieved.
B 315
Note: The battery is supplied partially charged. To ensure
C 316
full battery capacity, completely charge the battery in the
battery charger before using for the first time.
The lithium-ion battery can be charged at any time without
D 317
reducing its service life. Interrupting the charging procedure
E 317
does not cause damage to the battery.
F 318
The "Electronic Cell Protection (ECP)" protects the lithium-
G 318
ion battery against deep discharging. When the battery is
empty, the product is switched off by means of a protective
H 319
circuit: The product no longer operates.
Do not continue to press the On/Off switch after an auto-
matic shut-off of the product. The battery could become
damaged.
Observe the notes for disposal of the battery.
I 320
Inserting/Removing the Battery
J 320
Note: Using unsuitable batteries can lead to malfunctions or
K 321
damage the machine.
L 321
Insert the charged battery. Ensure the battery is inserted
correctly.
To remove the battery from the machine, press the battery
unlocking button and pull the battery out.
Charging Procedure
The charging procedure starts as soon as the mains plug of
the charger is plugged into a socket outlet and the battery is
inserted onto the charger .
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery
is charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
3 600 HB9 B..
84
96
= 1.5
< 2.5
= 1.5
Bosch Power Tools