Sony BRAVIA XBR-85X950G Manuel De Référence page 13

1
Remove the screws from the rear of the TV.
2
Attach the Wall-Mount Bracket (not supplied) using the screws (not supplied).
Note
• If using an electric screwdriver, set the torque at approximately 1.5 N·m {15 kgf·cm}.
Detaching the Table-Top Stand from the TV
To detach the Table-Top Stand from the TV, remove the screws
Note
• Be careful when lifting the TV as the Table-Top Stand is detached, the Table-Top Stand may topple over
and cause personal injury.
• Take care when removing the Table-Top Stand from the TV to prevent it from falling over and damaging
the surface that the TV is sitting on.
• Do not remove the Table-Top Stand for any reason other than to install corresponding accessories on the
TV.
• Be sure the TV is vertical before turning on. To avoid uneven picture uniformity do not power on the TV
with the LCD panel facing down.
• When attaching the Table-Top Stand again, be sure to fasten the screws (previously removed) to the
original holes on the rear of the TV.
Wall-Mount Bracket (not supplied)
Screw (not supplied)
.
US
13
US