KRESS BMH 600 CARBON Mode D'emploi page 7

BMH 600 - Buch Seite 7 Donnerstag, 17. August 2000 5:27 17
1 Application
The Pneumatic Drill Hammer can be used universally
for impact drilling, for light chiselling work in masonry
and for drilling as well as screwdriving in wood, metal
and plastic.
Safety Instructions and
2
Accident Prevention
Before putting the machine into operation, read
through these operating instructions completely and
observe the safety instructions contained therein as
well as those in the enclosed booklet on general
safety instructions for electro-tools.
If the mains cable is damaged while working, pull
the mains plug immediately.
Never work with a damaged mains cable.
Wear protective glasses, hearing protection, pro-
tective gloves and sturdy shoes.
For safety reasons, work only with the auxiliary
handle 12 mounted.
Do not work with materials containing asbestos.
Do not carry the machine by the cable.
The mains receptacles in the working area must be
protected by a residual current circuit breaker (RC).
For the attachment of identification markings on the
machine, do not drill into the housing. The protec-
tive insulation would be shorted. Use stickers.
When the drill unexpectedly jams, the machine
kicks back. Therefore, always take a secure stance
and hold the machine firmly with both hands.
3 Illustration
1 Tool holder
2 Dust protection cap
3 Unlocking collar
4 Gear selector/Rotation stop switch
5 Locking button for on/off switch
6 On/Off switch/Speed control
Ventilation slots
7
8 Latch for mains cable module
9 Rotational direction switch
10 Drilling/Impact drilling selector
11 Holder for depth stop
12 Auxiliary handle
13 Adapter for screwdriver bits/drill chuck
Accessories illustrated or described are not
always included as standard delivery items.
4 Technical Data
Pneumatic Drill Hammer
Input power
Output power
Electronic speed control
No-load speed
1st Gear
2nd Gear
Speed under load
1st Gear max.
2nd Gear max.
No-load impact rate
Impact energy
Right/Left rotation
Clamping collar dia.
Tool holder
Drill dia., max.
Steel
Light metal
Wood
Hammer drilling in conctrete
Recommended hammer
drilling range
Screw dia., max.
Wood
Sheet metal
Weight
Protection class
5 Noise/vibration information
Measured values determined according to
EN 50 144.
Sound pressure level: 84 dB (A)
Sound power level: 97 dB (A)
Workplace related emission value: 87 dB (A).
For operation, noise protection measures are
required.
The weighted acceleration is typically 8.6 m/s
Mounting the Auxiliary Handle and
6
the Mains Cable Module
Before any work on the machine itself, pull the
mains plug!
Operate the machine only with the auxiliary han-
dle 12. Mount the handle onto the clamping collar of
the drill, turning it to the working position and tighten-
ing it using the handle collar.
Connect the mains cable module to the handle. The
plug must latch.
English
7
600 W
300 W
•
0-1050 RPM
0-2250 RPM
0-800 RPM
0-1710 RPM
5194 per min. max.
2.3 J
•
43 mm
Euro standard
SDS-Plus
13 mm
18 mm
35 mm
22 mm
4-16 mm
8 mm
6.3 mm
2.75 kg
II /
2
.