Braun 7 Série Mode D'emploi page 13

On/off switch
w
«sensitive» (–) setting button
e
«intensive» (+) setting button
r
Reset button
t
Shaver display
z
Shaver-to-station contacts
u
Shaver power socket
i
Travel case
o
Special cord set
p
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
station power socket
• Press the lift button
• Hold the cleaning cartridge
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
fl uid is in the cartridge:
«high» up to 30 cleaning cycles available
«low» up to 7 cleaning cycles remaining
«empty» new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts
shaver will align with the contacts
cleaning station).
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
light up:
, connect the
p
to an electrical outlet.
6
to open the housing.
2
down on a fl at,
7
will show how much
1
on the back of the
u
in the
3
p
high high
low low
empty empty
will
5
high high
low low
1 1
emp ty emp ty
2 2
new new
high high
low low
high high
empt y empt y
low low
empt y empt y
high high high high
low low low low
empty empty empty empty
high high
low low
empty empty
13