Einhell Global ASB-G 24 Mode D'emploi page 9

Anleitung ASB-G 24 12-sprachig
Never allow the battery pack to discharge
completely. This will result in damage to the Ni-Cd
battery pack!
Adjusting the torque
The Einhell battery-powered drill/screwdriver is
equipped with a 10-step mechanical torque
adjustment facility. The torque for a specific size of
screw is selected with the set-collar (Figure 1). The
correct torque depends on several factors:
on the type and hardness of material in question
on the type and length screws used
on the requirements needing to be met by the
screwed joint.
The clutch disengages with a grating sound to
indicate when the set torque is reached.
Drilling / Hammer drilling (Figure 1)
For drilling turn the adjustment ring for the torque to
the „Drill" setting. For hammer drilling turn the
adjustment ring to the „Hammer" setting. In the
drilling / hammer drilling setting the slip coupling is
non-functional. Maximum torque is available for
drilling / hammer drilling.
Selecting 1st gear - 2nd gear (Figure 2)
You can work with a higher or lower speed
depending on how you set the selector switch. To
avoid causing damage to the gearing it is advisable
to change the gear only when the tool is at a
standstill.
Forward/Reverse switch (Figure 4)
With the slide switch above the On/Off switch you
can select the direction of rotation of the battery-
powered drill/screwdriver and secure it against being
switched on accidentally. You can choose between
clockwise and anticlockwise rotation. To avoid
causing damage to the gearing it is advisable to
change the direction of rotation only when the tool is
at a standstill. The On/Off switch is blocked when the
slide switch is in centre position.
On/Off switch (Figure 5)
Infinitely variable speed control is possible with the
On/Off switch. The further you press the switch, the
higher the speed of the battery-powered
drill/screwdriver in accordance with whichever gear
has been selected.
30.10.2001 9:05 Uhr
Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
Battery capacity reading (Figure 3)
Press the button next to the battery capacity LCD
when the battery is inserted. You can then read off
the current battery capacity in % from the LCD. The
percentage reading is higher for a charged battery
and lower for a discharged battery.
Technical data
Voltage supply
Speed 1st/gear/2nd gear
Torque
Forward and reverse rotation
Chuck clamping width
Battery charging voltage
Battery charging current
Mains voltage for charger
!
Old and defective batteries do not belong in the
refuse bin. Think of the environment! Cadmium is
toxic. For correct disposal, return old and defective
batteries postage-paid to ISC or take them to your
local old battery depot. Ask at your town hall for
details of the old battery depots in your area.
Seite 9
0-360 / 0-1100 rpm
230 V ~ 50 Hz
iNTERNATiONALES SERViCE CENTER GmbH
GB
24 V =
10 levels
yes
1.5 - 13 mm
29 V =
1,8 A
9