Operation Instructions; Service And Replacement Parts; Warranty; Disposal - erba 18041 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Remove the protective cap from the air coupling (3)
Screw the Euro-connector (4) into the air coupling.
It is recommended to use teflon tape on the thread of the Euro-connector to ensure an airtight fit.
Connect the die-grinder to the air compressor.
Make sure to install a pressure-regulator between the die-grinder and the compressor so you
can adjust the working pressure (max. 6,3 bar).
To change the grinding tools, open the tool holder (1) using the supplied spanners (5). Put a
suitable collet into the tool holder and put the required grinding bit into the collet. Fasten the tool
holder again and make sure that the grinding bit is held firmly in place by the collet.
To use the die-grinder push the on/off switch.

9. SERVICE AND REPLACEMENT PARTS

Use original spare parts only.

10. WARRANTY

Legal warranty regulations apply.

11. DISPOSAL

Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.

12. LEGAL INFORMATION

All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
18041
Issue: 06/2018