Operation Instructions; Service And Replacement Parts; Warranty; Disposal - erba 18030 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Connect the excentric grinder to the air compressor.
Make sure to install a pressure-regulator between the grinder and the compressor so you can
adjust the working pressure (max. 6.3 bar).
Put a suitable sanding disc on the disc holder (5)
Make sure that the holes in the sanding disc line up with the holes on the disc holder.
Set the grinder to the required speed using the RPM regulator (4).
To avoid excess dust in the air you should connect the dust collector bag (7) to the exhaust hose
(6) which in turn should be connected to the air exhaust (2).
Turn the grinder on by operating the on/off switch.

9. SERVICE AND REPLACEMENT PARTS

Use original spare parts only.

10. WARRANTY

Legal warranty regulations apply.

11. DISPOSAL

Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.

12. LEGAL INFORMATION

All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
18030
Issue: 10/2017