Operation Instructions - erba ER-33602 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

The angle grinder is equipped with a safety switch that prevents unintentional operation of the
machine. To switch the machine on, push the switch down and forward until it locks.
To switch the machine off, push the switch down and pull it backwards.
When using flat or depressed center grinding discs see image A for correct assembly.
When using depressed center cutting discs see image B for correct assembly.
When using flat center cutting discs see image C for correct assembly.
Note the different alignment of the lower flange piece (X) in the above images.
To change the discs first disconnect the machine from the power supply.
Press the spindle lock button (1) and turn the spindle until it locks.
Open the flange (4) with the spanner that comes with the machine.
Remove the flange piece (X)
Put the disc on the spindle.
Make sure that the inner diameter of the disc is the correct size. Never use reducing rings or
adapters if the inner diameter of the disc is too large - use a different disc instead!
Firmly screw the flange piece back on the spindle thread. Depending on the thickness and type
of disc you are using, the flange piece must be oriented accordingly (see images A, B and C)
Release the spindle lock button.
Let the machine run for 30 seconds without load (i.e. without cutting or grinding anything) to
make sure the disc rotates smoothly without any vibration.
Replace the cutting or grinding discs when they are worn down or damaged.
Always use the correct disc-type for the given application/material - never use cutting discs for
scrubbing!
When scrubbing, an angle of about 30-40° usually works best.
When cutting, make sure to move the disc in a straight line to keep it from jamming.
CAUTION: Do not work on materials that contain asbestos!
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
33602
Issue: 07/2017