Safety Instructions - erba ER-33602 Mode D'emploi

GB - INSTRUCTION MANUAL

1. SAFETY INSTRUCTIONS

Read this material before using this product. Failure to do so can result in serious injury. KEEP THIS
MANUAL. When giving this machine to third parties, always include this manual. We do not accept
any liabilities for accidents or damages that result from misuse. Removal/Alteration of any
safety devices or of the machine in general will result in the loss of warranty. The
buyer assumes all risk and liability arising out of his or her repairs/alterations to the
original product or replacement parts thereto, or arising out of his or her installation
of replacement parts thereto.
Always keep your work area well lit, clean and free of obstacles.
Do not use the product in the vicinity of ignition sources.
Keep children away from your work area.
Avoid contact with grounded surfaces (eg. pipes, radiators, etc.) to avoid the risk of electric shock.
Do not use the product in moist or wet areas.
Always use propper personal protection equipment (eye-protection, gloves, etc.).
Do not wear loose clothing, jewellery or any other accessory that might get caught in the machine.
If you have long hair, wear a hair-net.
Always disconnect the powercord when doing maintainance work.
Never leave the product unattended when children are present.
Check the product for any sign of damage each time before you use it.
Do not attempt to repair the product when it is damaged! Repair work must only be done by au-
thorized, qualified service technicians.
Only use discs that can withstand the max. rpm of the angle grinder.
Only use discs that with the correct diameter (115/125 mm)
Make sure the grinding disc is mounted correctly.
Do not use reducing rings or adapters to compensate for wrong diameter discs.
Do not use the machine to cut materials that are thicker than the max. cutting depth of the cutting discs.
Do not use cutting discs for deburring.
Check the discs thoroughly before each use - never use damaged discs!
Check the machine before each use. Let it run for 30 seconds without load. If it starts to vibrate,
use another disc. Do not use the machine if the problem persists. Repairs must be performed by
authorized professionals only.
Do not touch rotating discs.
When using discs that have a thread, it must be deep enough to take the full length of the
machine's spindle.
Make sure the ventilation slots on the back of the machine are clean and unobstructed. Always
disconnect the machine from the power supply when cleaning the ventilation slots.
Never use water for grinding/cutting with an angle grinder - mortal danger!
Always use the protective cover (5)!
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 11
Changes, print, punctuation and other errors reserved!
Instruction manual
33602
Issue: 07/2017