Product Description; Designated Use; Restrictions Of Use; Technical Data - erba 18041 Mode D'emploi

GB - INSTRUCTION MANUAL

2. PRODUCT DESCRIPTION

1 - Tool holder
2 - On/Off Switch
3 - Air coupling
4 - Euro connector
5 - Spanners

3. DESIGNATED USE

The die-grinder is designed for grinding, cutting, engraving and general shaping of parts while being
connected to a suitable air compressor. Any other use is prohbited. The buyer accepts all liabilities,
legal and otherwise, for any damage or injury resulting from improper use of the product (i.e. any
other use than the above stated designated use).
4. RESTRICTIONS
Please note, that this product is not designed for commercial or industrial use. We accept no liability
or warranty claims should the product be used in industrial and/or commercial operations.

5. TECHNICAL DATA

6 mm
Collets:
Working pressure: 4 - 6,3 bar
22.000 U/min
Max. RPM:
130 l/min
Air consumption:
91,6dB(A)±3dB
Sound pressure level L(pa):
102,6dB(A)±3dB
Sound pressure level L(wa):
4,3 m/s
Vibration on handle:
2

6. NOISE EMISSION VALUES

See technical data - use of ear protection is recommended.

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

See operation instructions.
Page 10
Instruction manual
ERBA GmbH
18041
A-1230 Wien
Issue: 06/2018
Talpagasse 6
Changes, print, punctuation and other errors reserved!
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at