AEG SKB58821AS Notice D'utilisation page 22

22 www.aeg.com
7.1 What to do if...
Problem
The appliance does not op-
erate.
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger-
ator.
Water flows on the floor.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not suppor-
ted properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified elec-
trician.
Check if the appliance
stands stable.
Close and open the door.
Refer to "Replacing the
lamp".
Refer to "Operation" chap-
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.