Cleaning; Connecting The Unit; Electric Connection - Zanotti SP1 Mode D'emploi Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.8 Cleaning

Clean the unit carefully. Remove any dust, foreign substances and dirt possibly deposited during handling.
Use detergents and degreasers.
ATTENTION
Solvents are not allowed.

7. CONNECTING THE UNIT

ATTENTION
Before connecting the unit make sure that mains voltage and frequency correspond
to the values show n in the data plate. Voltage tolerance: +/ - 10 % compared to
nominal value.

7.1 Electric connection

Connect the unit after checking the panel components.
ATTENTION
Connection to the electric line shall be effected applying a suitable safety device ( a
circuit breaker or a ground fault interrupter) selected by the installer on the basis of
the line involved and of the absorption indicated on the unit plate.
If a cold room includes more units, each unit shall be provided with its own safety device. Connect the
unit paying attention to the colours of the supply cable wires:
We advise to install a microswitch (not supplied) on the cold room door which will:
Switch on the light in the cold room, stop compressor and evaporator fan.
-
Override the temperature alarm (for about one hour after door closing) every time the door is opened.
-
Should microdoor, cold room light, door heater be necessary, carry out following connections:
Microdoor
Remove the jumper between terminals ID3 of the electronic control box and connect the microdoor
cable according to the following condition: closed contact with closed door.
Cold room light
Connect as shown in the wiring diagram. Cold room lamp features: 230 Volt and 100 Watt max.
Door heater
Connect as indicated by the plate on terminal board. Heater is indicated by "EP". Output voltage: 230
Volt.
WARNING
Any defective electrical part should be replaced by trained personnel exclusively. The electric
connection should be effected by qualified personnel.
a) 230V/1/50-60Hz
b) 230V/3/50-60Hz
c) 400/3/50 Hz
3 wires
Blue = Neutral
Yellow/Green = Ground
Brown = Phase
4 wires
Grey = Phase
Yellow/Green = Ground
Brown = Phase
Black = Phase
5 wires
Blue = Neutral
Yellow/Green = Ground
Brown = Phase
Black = Phase
Grey = Phase
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Spo 121Spo 122Spo 123Sp2Spo 221Sp3 ... Afficher tout

Table des Matières