Phottix Strato TTL Manuel D'utilisation page 13

7. Metering Mode: Setting Average or
Evaluative metering mode for the flash
through camera menu is supported.
8. Changing Channels: After enabling
wireless flash functions on the camera, flash
transmission channels can be changed in the
camera menu. Changes made to channels in
the camera menu will change the working
channel of the Strato TTL Transmitter on the
camera.
Please note:
- If the "wireless flash functions" in the camera
set-up menus has been enabled Second
Curtain Sync Functions will not work. The
"Wireless flash functions" selection needs
to be disabled to use Second Curtain Sync
functions.
EN
Connecting the Strato TTL receiver
to flashes or studio lights by sync
cable
1. Turn off the flash/studio light and the
Strato TTL receiver.
2. Connect a cable to the receiver's 3.5 mm
Sync Port.
3. Connect the opposite end of the cable to
a flash or studio strobe (A 6.3 mm adapter is
included for studio strobes with larger ports).
4. Turn on the flash/strobe and the Phottix
Strato TTL receiver. Set the flash/strobe to
Manual mode (if applicable).
5. Press the Shutter Button of the camera
connected to the transmitter -- flashes
INSTRUCTION MANUAL
13