Operation; Switching On The Whirltub; Switching Off The Whirltub; Durapearl Jets - DURAVIT Combi-System L Notice D'utilisation

6. operation

NoTIcE
Disinfect the whirltub system before using it for the first time, and
then after every tenth bath, but at least once a month and after a long period of no use.

6.1 Switching on the whirltub

NoTIcE
Switch off the whirltub when finished.
> Switch on the main switch.
The display buttons light up briefly one after another from the "On/Off" button to the
"Foot jets" button.
> Activate the display by holding down the "On/Off" button.
! The whirltub system can only be switched on when the water level is 5 cm above the
uppermost jet.
! Turning on the air-water or water massage also activates the heater and UV hygiene
management system.

6.2 Switching off the whirltub

> Wait until the tub is completely drained and the 2-minute drying mode is finished
(Durapearl jets automatically activated, "Durapearl" button flashes).
> Switch off the main switch.

6.3 Durapearl jets

Switching on / off

> Press the "Durapearl" button.
The jets are switched on/off (air-water massage).
30