General Information; Power Failure - Agilent Technologies Varian Analog TSP Notice De Mode D'emploi

GENERAL INFORMATION

This equipment is destined for use by professionals.
The user should read this instruction manual and any
other additional information supplied by Varian before
operating the equipment. Varian will not be held
responsible for any events occurring due to non-
compliance, even partial, with these instructions,
improper use by untrained persons, non-authorised
interference with the equipment or any action contrary
to that provided for by specific national standards.
The following paragraphs contain all the information
necessary to guarantee the safety of the operator when
using the equipment. Detailed information is supplied in
the section "Technical Information".
This manual uses the following standard protocol:
!
The warning messages are for attracting the attention
of the operator to a particular procedure or practice
which, if not followed correctly, could lead to serious
injury.
CAUTION!
The caution messages
procedures which, if not followed, could cause damage
to the equipment.
The notes contain important information taken from the
text.
STORAGE
When transporting and storing the Controller, the
following environmental
satisfied:
•
temperature: from -20 °C to + 70 °C
•
relative humidity: 0 - 95% (without condensation)
WARNING!
are displayed before
NOTE
requirements should
PREPARATION FOR INSTALLATION
The controller is supplied in a special protective
packing. If this shows signs of damage which may have
occurred during transport, contact your local sales
office. When unpacking, ensure that the module is not
dropped or subjected to any form of impact. Do not
dispose of the packing materials in an unauthorised
manner. The material is 100% recyclable and complies
with EEC Directive 85/399.
INSTALLATION
The controller is equipped with a 3-wire power cord.
Use this power cord
grounded power socket to avoid electrical shock.
The controller must be installed inside a rack module,
but it must be positioned so that free air can flow
through the holes. Do not install or use the controller in
an environment exposed to atmospheric agents (rain,
snow, ice), dust, aggressive gases, or in explosive
environments or those with a high fire risk.
During operation,
conditions must be respected:
•
temperature: from 0 °C to +45 °C
•
relative humidity: 0 - 95% (without condensation)
The following paragraph describes the fundamental
operating procedures.
Make all vacuum manifold and electrical connections
and refer to the pump instruction manual prior to
operating the controller.

Power Failure

be
In the event of a power failure (momentary or long
period) the controller is switched off. When power is
restored, the controller will automatically restart.
4
INSTRUCTIONS FOR USE
!
WARNING!
in conjunction with a properly
NOTE
the following environmental
87-900-118-01 (C)