Brother KIT I Guide D'installation page 9

The certification key has been successfully obtained.
Now proceed to installing the upgrade program for KIT
I
on the sewing machine.
Use USB media or a computer to install the upgrade
program.
If USB media is to be used, refer to the instructions that
follows in [Step 4] on page 7.
If a computer is to be used, refer to the procedure
described in [Step 4] on page 8.
When using USB media to perform the installation
[Step 4]
k
While pressing the "Automatic Threading"
button, turn the sewing machine on.
l
Copy the upgrade program downloaded in
d
step to the USB media.
Note
• Copy only the upgrade program to a clean
reformatted USB media; no other files should be on
this media.
m
Insert the USB media into the primary (top)
USB port connector on the right side of the
machine. It will take a few seconds until the
machine recognizes that the USB media has
been inserted into the port.
n
Press .
o
Press .
Note
When the message "Upgrade complete." appears,
installation of the upgrade program has been
completed.
(If an error occurs, a message will appear in red.)
[Step 5]
p
Remove the USB media.
q
Continue with step on page 9.
7