Copying To A Remote Control In Operation - Velux VSE KLR 100 Notice D'utilisation

Copying to a remote control in operation

If you have two remote controls with different products
registered in them, you can copy the contents from one to
the other and vice versa. Then all products can be oper-
ated with both remote controls.
The example shows how to copy the products from re-
mote control A to remote control B and at the same time
maintain the settings and the programs of both remote
controls.
Step 1: Change security key in remote controls A and B
Change the security key in both remote controls so that
they have the same security key, see section Security key.
Step 2: Register the products in remote control A
Register all products in remote control A by choosing:
menu system settings
If in doubt, see section Registering new products.
Remote control A can now operate both the products
from remote control B and the products it could already
operate.
Step 3: Register the products in remote control B
Register all products in remote control B by choosing:
menu system settings
Remote control B can now also operate both the products
from remote control A and the products it could already
operate.
After this both remote controls can operate all products.
60 VELUX
A
Register product
Register product
ENGLISH
Note: With the shown procedure, only the products are
copied from remote control A to remote control B and
vice versa. If you want an exact copy of remote control
A with all personal settings such as Names, Rooms and
Groups, you must proceed differently after step 2. First
B
reset remote control B, see section Resetting the remote
control. Then copy from remote control A as described in
section Copying to a new remote control.
ENGLISH
VELUX 61