Registration Of Product Using A Klr100 That Is Already In Use - Window Master WIC 01M Instructions D'installation

Registration of product using a KLR100 that is already in use

All products, that are to be operated by the remote control, must be registered in this. The method used depends on
whether it is a new remote control or if other products have been registered in it previously.
In this section, the approach when a newly installed WIC 01M is to be set up with a remote control that is already in use
is described.
If the mains supply is connected to the WIC 01M in question, disconnect it for
1.
one minute. Afterwards reconnect power.
"Menu" on the remote control.
Press
2.
Continue through the menus: System settings -> Register product.
3.

The remote control is now in the "Auto set-up" state. It registers
the WIC 01M automatically. When this is done the remote
control will show any registered product.
Any connected sun screen product e.g. a blind, will also be registered. Is it the first blind in the
system it will be showed as "No. 1 – Blind".
Unless "Rooms" have been set up the new product will be placed in "House". Is it e.g.
the second window that has been registered, it will get the name "No. 2 – Window"
Please address the full manual for the remote control for more advanced possibilities regarding the establishment of
"Groups" and "Rooms".
9