Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Set up of previously registered WIC 01M using the KLR 100
This procedure should be followed when a WIC 01M that has been registered previously, is to be set up with a remote
control of the type VELUX KLR 100.
When the WIC 01M has been registered previously, it is necessary to reset it, in order to register it again.
Mount all actuators and sensors.
1.
Connect all cables.
2.
Slide of the battery cover from the rear side of the remote control. Insert the
3.
three supplied batteries (type AA, 1,5V) into the remote control. Replace
Cover.
Choose language on the remote control.
4.
NB: The following steps 5-8 must be completed within 10 minutes.
Connect mains supply to ONE WIC 01M.
5.
Press the "Program button" on the WIC 01M shortly.
6.
If the window is not already closed wait until it is, before continuing to
step 7.
Press and hold the "Program button" for 5-10 seconds until the window starts
7.
going back and forth.
The WIC 01M is now in the "auto set-up" state for approximately 10
minutes and it can be registered by the remote control in this period.
If one fails to re-register the WIC 01M during the 10 minutes it will
remain unregistered until a new registration is carried out.
Press "Ready"
8.
The remote control is now in the state "auto-setup" and will register
the window automatically. When this is done the window stops
moving back and forth - if they have not stopped already - and
closes. The remote control will remain in the state for approximately
one minute.
The displays indicates a registered product – i.e. "No. 1 - Window". This
9.
window is now operable. The new window will by default be placed in the
setting "House".
The window just registered will be placed subsequently to previously registered windows.
If i.e. two windows have been registered it will be placed as "No. 3 – Window".
Any attached sun screen product, e.g. a blind, will also be registered at this point.
on the remote control.
10
Publicité
Table des Matières
